MDLR CASE erformer Series Pro 14u/126HP (Configurable)

MDLRCASE Performer Series Pro 14u/126HP (Configurable)

This 14U case features two extra 1U rows for use with both Intellijel 1U format or Pulp Logic/Erthenvar tiles.

Specifications

• This case is compatible with both Pulp Logic / Erthenvar and Intelijel 1U format
• Choose your own rails configuration for top and bottom case halve
• Mix and match if you like, one case halve Pulp Logic 1U + one case halve Intellijel 1U. You choose not us.
• 12mm birchwood fully nailed and glued construction
• Sprayed with a special 2-layer black protective coating
• Detachable middle ring/spacer allows modules to be fully-patched during transport
• Spacer functions as a rock-solid stand when the case is open
• Flush-mounted rails allow the modules to be mounted even with the sides of the case
• Top and bottom sections can be detached and set up side-by-side as two separate 7U cases
• Twelve 126HP  rails with M3 threaded inserts
• Two 45W or 85W MDLR PWR powered busboards (80 power headers in total)
• Two MDLR PWR extension boards (total of 14 extra headers)
• Total output (both case halves)  45W    4A on 12V, 2.5A on -12V and 3A on 5V
• Total output (both case halves)  85W    8A on 12V, 5A on -12V and 6A on 5V
• Two side-mounted power switches
• Two 1.8m power cords
• Power adapters included
• High-quality Penn Elcom components
• Super-comfortable Luxe carrying handle
• Anti-slip rubber feet
• Completely assembled, wired, tested, and ready to play!

• 70,5 cm x 37,5 cm x 25 cm

• 11,9. kg (includes rails, power supplies, and other hardware)

• 6,9 cm available depth between top of rail and bottom of case
• 6.2 cm available depth between top of rail and busboard
• 4.2 cm available depth between top of rail and protection plate PSU part
• 5.3  cm available depth between top of rail and top of header on busboard

• Other Input common-mode LC filter with high efficiency of canceling noise and interference from input connector
• Additional input filter on each regulator for minimal output noise and interferences
• Shield for reducing RF interferences from regulators
• Star distribution topology on PCB
• Each “beam” from star topology has 4 headers with noise canceling capacitors.
• In star topology center are another noise canceling capacitors
• A big ground plane on both sides of PCB
• Blue LEDs indicate present and drop of output voltage
• Recommended power brick for one board – Mean well GSM60A18-P1J