- Centre frequency range 16Hz to 16KHz
- 1V/octave, Coarse and Fine frequency controls
- FM input with attenuverter
- Low pass 12 dB/octave
- High pass 12 dB/octave
- Band pass 6 – 12 dB/octave dependent on Q
- Notch with variable offset –/+ 2 octaves
- Input with gain control
- Inverted input with resonance dependent gain
- Strike input for pinging the filter
- Feedback switch which adds BP to the input for enhances resonance
- Limiter based on tanh wave shaper which affects primary input (post gain fader)
Instruo I-o47
Multimode Resonator/Filter
€ 338,00 € 275,00For European customers, please select your country to view the correct price including vat
Arriving shortly
Contact us to verify delivery times
KEEP IN TOUCH
Find out our opening hours
Your Contact for the Synthesizers Department

Showroom Sintetizzatori:
Lun - Mer: 10:00 - 13:00 / 14:00 - 18:00
Giov - Ven: 10:00 - 13:00
Reparto Pro Audio:
Lun - Ven: 10:00 - 13:00 / 14:00 - 18:00
Visite su appuntamento
Arriving shortly
Contact us to verify delivery times
-
Free Shipping
Free Shipping
For all orders over € 250, shipping in Italy will be free. All our shipments are managed by national and international couriers with express service to guarantee delivery in 24h * from the dispatch of the goods from our warehouse. * For the islands and some remote areas the timing could increase to 48h. -
After Sale Support
After Sale Support
At your side to grow with you. Behind this website there are real people who work every day to always offer the best possible service and give maximum support even after the purchase. - 2 Years Warranty
- Secure Payments
- Centre frequency range 16Hz to 16KHz
- 1V/octave, Coarse and Fine frequency controls
- FM input with attenuverter
- Low pass 12 dB/octave
- High pass 12 dB/octave
- Band pass 6 – 12 dB/octave dependent on Q
- Notch with variable offset –/+ 2 octaves
- Input with gain control
- Inverted input with resonance dependent gain
- Strike input for pinging the filter
- Feedback switch which adds BP to the input for enhances resonance
- Limiter based on tanh wave shaper which affects primary input (post gain fader)
Instruo I-o47
Multimode Resonator/Filter
I-ō47 Multimode Resonator/Filter draws its circuit design inspiration from the classic 1047 module of the ARP2500 system.
Built upon the classic circuit architecture of the original, the design was refined with extensive experimentation using modern components along side classic configurations of discrete parts.
The internal VCA’s are a new hybrid design of matched transistors and precision op-amps.
Various refinements were also added such as voltage control over the variable notch offset which opens new worlds of dynamic sweeps and shaping.
There are two audio inputs on the I-ō47. The top runs through a gain stage, set by the fader, and has an optional limiter in line with it selected by the LIM toggle switch.
This limiter is an implementation of the tanh wave shaper circuit which applies the soft curvature of the tanh expression to any input signal. The gain fader sits before the limiter allowing for precise control over the amount of warm saturation that occurs with this style of limiting.
With a simple sawtooth wave, the limiter will gently curve the ramp and result in subtle enhancement of the low end of the signal’s tone.
For more complex audio signals (drum voices work a treat!) the limiter will give very musical results akin to gentle compression/overdrive, all the way to limiting and saturation.
The inverting input inverts the polarity of the input signal. This input is also directly affected in amplitude by the Q (resonance) control. As resonance increases, the signal amplitude will decrease, acting as a form of automatic gain compensation.
Both inputs can be used simultaneously to mix two independent audio signals.
The variable Notch effectively crossfades between branches of the low-pass and high-pass signals. The result is an offset notch response that can shift up or down a couple of octaves from the centre frequency.
This part of the circuit was inspired directly from the 2500’s 1047 variable notch control.
CV was added by means of an optimised linear crossfading VCA pair. (The versatility of the variable notch output became apparent early on in development, so CV control was made a priority!)
Q (resonance) is CV controllable.
The feedback toggle sends an additional branch of the band-pass signal to the non-inverting input and allows for stable self oscillation of the Filter. It can be used to kick the resonance response up a gear.
The strike input can be used to ‘ping’ the resonance of the filter. It is designed to respond to signals at audio rate which allows for its use as an input for square wave tones.
Specifications
Size
- 14HP
- Depth: 27mm
Power
- +12V: 50mA
- –12V: 50mA
Specifications
- Centre frequency range 16Hz to 16KHz
- 1V/octave, Coarse and Fine frequency controls
- FM input with attenuverter
- Low pass 12 dB/octave
- High pass 12 dB/octave
- Band pass 6 – 12 dB/octave dependent on Q
- Notch with variable offset –/+ 2 octaves
- Input with gain control
- Inverted input with resonance dependent gain
- Strike input for pinging the filter
- Feedback switch which adds BP to the input for enhances resonance
- Limiter based on tanh wave shaper which affects primary input (post gain fader)
Depth | 27 mm |
---|---|
Width |
Only logged in customers who have purchased this product may leave a review.
Return and restocking option is available for private customers only.
We will issue a refund/credit if you are not satisfied with your purchase and notify us within 10 days of product receipt.
It must be returned in the original packaging and in saleable condition and must be returned freight prepaid.
Return and restocking rights are not applicable for Audio/Video software products.
Shipping and handling charges to and from are not refundable.
You might also be interested in one of the following products
-
Endorphin.es Gateway
€ 249,00For European customers, please select your country to view the correct price including vat
Brand: Endorphine.es
Gateway as expander for Endorphin.es’ Terminal module
Arriving shortly
Contact us to verify delivery times -
Out of Stock
Free shipping in Italy
-
Make Noise MMG
€ 268,40For European customers, please select your country to view the correct price including vat
Brand: Make Noise
Voltage Controlled Filter and Low Pass Gate
Out of Stock
Free shipping in Italy
-
Doepfer A-107 Multitype Morphing Filter
€ 305,00For European customers, please select your country to view the correct price including vat
Brand: DOEPFER
The filter design is 100% analog (CEM filter chip) 26 very different filter types
Out of Stock
Free shipping in Italy
Reviews
There are no reviews yet.