Neumann USM 69 i – mt

Microfono da studio a condensatore Stereo

 5.414,00 ( 4.437,70 + iva)

Disponibile

Spedito in 4 - 8 giorni

- +
Add to Wishlist
Acquista in comode rate a partire da 174,45 / mese
Finanziamento a Tasso Agevolato
(Tan 9,90% - Taeg 10,59%)
Richiedi maggiori informazioni

Disponibile

  • Two independent systems with 5 polar patterns each
  • Same large diaphragm capsules as U 87 Ai
  • Upper system rotates up to 270° for XY and MS techniques
  • Transformer balanced circuit with very low self-noise
  • Spedizione gratuita
  • Supporto Post-Vendita
  • Garanzia di 2 anni
  • Finanziamenti Agevolati
  • Noleggio Operativo
  • Pagamenti Sicuri

Neumann USM 69 i – mt

Microfono da studio a condensatore Stereo

Compact switchable stereo microphone for MS and XY stereophony, with freely adjustable pickup angles and selectable directional characteristics.

The USM 69 i stereo microphone has two separate dual-diaphragm capsules. These are mounted vertically and rotate against each other. The directional polar patterns can be selected separately for each capsule. The capsules operate independently from each other.

Applications

The USM 69 i condenser stereo microphone is a studio microphone for intensity stereo recording. It is suitable for XY and MS recordings.

Construction

The microphone consists of the amplifier section and the capsule head. The amplifier section contains two microphone amplifiers operating independently from each other. They have an extremely low self noise.

Two completely separate microphone capsules are positioned closely above each other within the capsule head. Their diaphragms are made out of gold-sputtered polyester film. The upper capsule rotates against the lower one over a range of 270°. Color markings on the lower capsule system help to identify the angle by which the upper capsule has been rotated.

When sound waves reach the microphone capsules from different directions they will generate audio signals with different intensity only, but not with time differences, since the capsules are in close proximity and the sound arrives at both capsules simultaneously. The result is an intensity stereo signal that can be summed together for excellent mono compatibility without causing interference.

Polar patterns

The USM 69 i has two built-in rotary switches. The five polar patterns of both capsules can be selected at the microphone itself. Therefore, no special AC power supply units or powering adapters are necessary. The two outputs attach directly to any 48 V phantom powered connectors.

In addition to the usual polar patterns: omnidirectional, cardioid, and figure-8, we have added a hypercardioid and a wide-angle cardioid pattern. A built-in DC converter generates the required capsule polarizing voltages.

Electrical features

The amplifiers feature high output capability and extremely low self noise. Distant sound sources, as well as very loud sound sources at close range can therefore be recorded without any problem.

Each amplifier has an active filter. It effectively suppresses subsonic interference as caused by wind or structure borne noise. At the same time, the filter prevents the output transformers from overloading through very low frequency energy.

Use as a mono microphone

The microphones may also be used as completely independent mono microphones. There are many applications when it is important to have a second mono microphone as a backup, or when the outputs of microphones with different polar response characteristics must be available simultaneously.

The outputs of the two microphone channels can be linked (cascaded). In addition to the individual directional patterns, other characteristics are available through the combination of both channels.

Operational safety

Both microphone systems operate completely independent from each other. The second amplifier will be unaffected, even in case of a faulty ground of the supply voltage for one of the channels, or a short circuit in one of the outputs. The microphone is reliable in mono usage, even if only one of the systems is operated and connected. Its simple and redundant circuitry guarantees a low failure rate. Should the DC converter ever fail, a diode circuit within the microphone ensures that both systems will remain operational. The cardioid pattern is automatically chosen. The sensitivity is reduced by 3 dB.


Specifiche Tecniche

Acoustical operating principle Pressure gradient transducer
Directional Pattern Omnidirectional, wide-angle cardioid, cardioid, hypercardioid, figure-8
Frequency Range 20 Hz … 20 kHz
Sensitivity at 1 kHz into 1 kohm 13 mV/Pa
Rated Impedance 150 ohms
Rated load impedance 1 kohms
Equivalent noise level, CCIR 1 24 dB
Equivalent noise level, A-weighted 2 13 dB-A
Maximum SPL for THD 0.5% 3 132 dB
Signal-to-noise ratio, CCIR (re. 94 dB SPL) 4 70 dB
Signal-to-noise ratio, A-weighted (re. 94 dB SPL) 5 81 dB
Maximum output voltage 3 dBu
Supply voltage (P48, IEC 61938) 48 V ± 4 V
Current consumption (P48, IEC 61938) 2 x 0.7 mA
Matching connector XLR 3 F
Weight 510 g
Diameter 30 + 48 mm
Length 293 mm
1)according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2)according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
3)measured as equivalent el. input signal
4) according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
5) according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
Dimensione capsula

Recensioni del cliente

Recensioni

Non ci sono ancora recensioni.

Solo gli utenti connessi che hanno acquistato questo prodotto possono scrivere una recensione.

In conformità con quanto previsto dal Decreto Legislativo 6 settembre 2005 n. 206 (e successive modifiche ed integrazioni), il cliente Consumatore, ove non soddisfatto dei prodotti ovvero del contenuto dei servizi acquistati presso il Venditore, potrà restituire i prodotti medesimi o rinunciare al diritto alla prestazione dei servizi ed ottenere il rimborso del prezzo già corrisposto in sede di pagamento anticipato.

Il diritto di recesso-restocking è applicabile solo ed esclusivamente per acquisti operati da persone fisiche (consumatore) e quindi per acquisto di beni non utilizzati professionalmente e per vendite iniziate e risolte a distanza.

Gli articoli acquistati possono essere resi entro 14 giorni successivi alla consegna dei prodotti ovvero entro i 14 giorni successivi all’acquisto dei beni o dei servizi, inviando una comunicazione via raccomandata A.R. all’indirizzo via F. Sabatini, 10 – 00135 Roma, contenente tutte le informazioni necessarie ed utili ad una corretta elaborazione della pratica di restituzione e rimborso.
Tale comunicazione dovrà necessariamente contenere tutto quanto di seguito indicato:
a. l’espressa volontà del Cliente di voler recedere in tutto o in parte dal contratto di acquisto;
b. il numero e la copia del documento (fattura – documento di trasporto) comprovante l’acquisto dell’ordine rispetto al quale si intende esercitare il diritto di recesso;
c. la descrizione ed i codici dei Prodotti rispetto ai quali si esercita il diritto di recesso.

Il riaccredito, comprensivo delle spese di spedizione, verrà effettuato dal Venditore entro 14 giorni dalla ricezione della comunicazione via raccomandata A.R. sopra citata.

Sono tuttavia esclusi dal diritto di recesso i seguenti articoli:

Prodotti audiovisivi o i software informatici sigillati, aperti dal consumatore
Beni confezionati su misura o chiaramente personalizzati
Il materiale dovrà ritornare integro e completo dell’imballo originale e dei manuali d’uso.
Le spese di spedizione per il reso delle apparecchiature sono a carico del consumatore.

Per maggiori informazioni:
http://www.parlamento.it/parlam/leggi/deleghe/99185dl.htm

Start typing and press Enter to search

Shopping Cart
neumann-usm-69-i-mt-milk-audio-store